Faculty of Engineering and Technology

Permanent URI for this community

https://kwasuspace.kwasu.edu.ng/handle/123456789/8

Browse

Browsing Faculty of Engineering and Technology by Author "A.O. AJAYEOBA"

Now showing 1 - 1 of 1
  • Thumbnail Image
    Item
    COMPUTER AIDED DESIGN OF HELICAL GEAR
    (University POLITEHNICA Timisoara, Faculty of Engineering Hunedoara, Romania., 2019-02-01) K.O. OLADOSU; A.O. AJAYEOBA; B.O. AKINNULI; M.O. ADEWUMI
    In recent times, the gear design has become a highly complicated and comprehensive subject. A designer of a modern gear drive system must remember that the main objectives of a gear drive is to transmit higher power with comparatively smaller overall dimensions of the driving system which can be constructed with minimum possible manufacturing cost, runs reasonably free of noise and vibrations and which requires little maintenance. As a result, an interactive user friendly low cost software HelOSpur2011” was developed to relieve designer of analytical way of calculating needed parameters for design of helical and spur gears, generating reliable data for use in manufacturing process. The software is able to produce accurate and efficient 2D (two dimensional) and 3D (three dimensional) detail working drawings as a result of interactive computer graphics and provide substantial saving in time and cost of production. Results generated by the software shows that the computed face width (for strength check) and wear check for helical gears design as against manual methods were in relative error of 0.64% and 0.35% respectively. Relative accuracy of the software stand at 99.6%.The work has demonstrated the effectiveness of using the software to cater for helical gear design problems as well as spur gears when helix angle is zero. The introduction of this software to the society will in no small way increase productivity and reliability of helical and spur gears design.